Garage Door Remote Control Receiver Rx Multi 300- 868MHz Universal Switch

Universal 2-channel Receiver - Multi-frequency: 300-900MHz

Specifications:

1) Name: Universal receiver SMG-662.
2) Operating Voltage: 9V-30V.
3) Channels: 2.
4) Frequency: 300MHz - 900MHz.
5) Range: 30-50 meters.
6) Very compact size: 5.5cm*4.5cm*1.0cm.
7) One receiver can work with 400 codes.
8) It doesn't interfere with other remotes and receivers.
9) Brand selector: With 8 dip switches, users can configure different combinations for different remote brands.
10) Code: Rolling and Fixed code & Learning code.
11) Uses: The receiver is designed to control gate automation systems, burglar alarm systems, electric doors, windows, lifting equipment, gateways, and lifting devices. It's easy to use, good-looking, low-power consumption, and can be easily connected to your existing system.
12) Power Input Selector: This receiver can work with AC/DC 9V~30V. However, it's better to adjust the PIS according to the power input. If the input is greater than 24V, shorten pin 2&3; shorten 1&2 if the input is less than 24V.

Working frequency: 300-900MHz (Rolling code & Fixed code)

300MHz
310MHz
315MHz
318MHz
390MHz
433.4MHz
433MHz
433.92MHz
868MHz
868.3MHz
868.8MHz

Can identify ALL Fixed codes (2262, 2260, 2264, 5326, M1E, M5E, and so on). All Learning codes (1527, 2240, 6P20B, 6P20D, and so on), Rolling codes (HCS301, HCS300, HCS200, HCS201, HCS100, HCS101).

Includes:

1x Receiver
1x Small Antenna
1x English Manual

Programming a new remote:

1) Select the correct brand for the remote to be programmed by moving dip switches UP or DOWN. For example, for 433.92MHz Marantec remote controls, just move Dip-switch 7 UP.

2) Press the learn button. The LED will turn on.

3) Press the button on the remote, the LED will flash 4 times. It means that the remote control was programmed successfully.

4) Repeat step 2 for another button.

5) The 2nd channel programming procedure is the same.

To erase all data from the memory card: Press and hold either learn button. The LED will start to flash. Keep this button pressed until the LED turns off. All saved data on the memory card will be permanently erased and cannot be recovered.